Write in a clean editor, then format for Journal of Strain Analysis in one click — DocuGuru applies the official SAGE template with author–year references and exports a submission-ready PDF plus the editable LaTeX source. Free to start.
Journal of Strain Analysis is a peer-reviewed journal published by SAGE, covering Fatigue and fracture mechanics, Structural Load-Bearing Analysis, Metal Forming Simulation Techniques.
| Publisher | SAGE |
|---|---|
| Reference style | Author–year (Harvard) Author–year — (Smith, 2023) in the text Smith, A., Jones, B. and Lee, C. (2023) 'A representative article title', Journal of Strain Analysis, 12(3), pp. 45–58.
Formats any DOI in Journal of Strain Analysis style. No sign-up. |
| Publishes research in | Fatigue and fracture mechanics Structural Load-Bearing Analysis Metal Forming Simulation Techniques Composite Structure Analysis and Optimization Engineering Structural Analysis Methods |
| ISSN | 0022-4758 |
| h-index | 37 |
| i10-index | 150 |
| Total citations | 6,864 |
| Top institutions publishing here | University of Nottingham |
| You get | A submission-ready PDF and the editable LaTeX source — ready to submit. |
Citations each year’s papers have accumulated so far — the most recent years are still building up.
Stresses in a standard metal-to-metal adhesive-bonded lap joint are analysed by a two-dimensional finite-element method and comparisons are made with previous analyses. Particular attention is paid to the stresses at the ends of the adhesive layer. Unlike previous work, which assumes the adhesive to have a square edge, the adhesive spew is treated as a…
A sealed reactor fuel can when subjected to sufficiently high thermal stresses in the presence of an internal pressure will yield plastically. A simple model of the can is used to show that the plastic strains so produced may cause ratchetting or plastic cycling as the temperature gradient across the can wall cycles because of…
An introduction is given to the fracture mechanics approach employing the concept of crack opening displacement for application to situations in which linear elastic fracture mechanics is invalidated by yielding. The hypothesis of a critical crack opening displacement to fracture has been examined experimentally using mild steel specimens of vastly differing dimensions. Subsidiary experiments have…
A non-conforming displacement triangular finite element is derived with quadratically varying displacements for use in plate-bending problems. It is shown that the element corresponds with a known constant-bending-moment element and provides, in consequence, an over-estimate of the influence coefficients. Convergence is also assured in advancing to successively finer mesh sizes. A few simple test problems…
The problem of minimizing stress concentrations in machinery components is formulated as one of unconstrained minimization by incorporating all ‘side’ constraints on design variables by use of penalty functions. Design parameters describing the transition are determined for an optimal fillet in a tension bar, as well as for a piston-rod ‘eye’. The procedure is generally…
