IOP Publishing

Clinical Physics and Physiological Measurement Template

Write in a clean editor, then format for Clinical Physics and Physiological Measurement in one click — DocuGuru applies the official IOP Publishing template with numbered references and exports a submission-ready PDF plus the editable LaTeX source. Free to start.

About the Clinical Physics and Physiological Measurement format

Clinical Physics and Physiological Measurement is a peer-reviewed journal published by IOP Publishing, covering Electrical and Bioimpedance Tomography, Hemodynamic Monitoring and Therapy, Body Composition Measurement Techniques.

PublisherIOP Publishing
Reference styleNumbered (IOP)
Numbered — [1], [2] in the text
[1] Smith A, Jones B and Lee C 2023 A representative article title Clinical Physics and Physiological Measurement 12 45–58

Formats any DOI in Clinical Physics and Physiological Measurement style. No sign-up.

Publishes research inElectrical and Bioimpedance Tomography Hemodynamic Monitoring and Therapy Body Composition Measurement Techniques Geophysical and Geoelectrical Methods Non-Invasive Vital Sign Monitoring
ISSN0143-0815
h-index59
i10-index273
Total citations12,738
Top institutions publishing hereRoyal Hallamshire Hospital
You getA submission-ready PDF and the editable LaTeX source — ready to submit.

Papers published in Clinical Physics and Physiological Measurement per year

31
1982
40
1983
31
1984
34
1985
30
1986
57
1987
61
1988
62
1989
63
1990
69
1991
72
1992
1
2013

Citation impact of Clinical Physics and Physiological Measurement by publication year

566
1982
302
1983
367
1984
713
1985
565
1986
2.6K
1987
1.4K
1988
1.4K
1989
1.1K
1990
1.4K
1991
1.2K
1992
29
2013

Citations each year’s papers have accumulated so far — the most recent years are still building up.

Most-cited papers in Clinical Physics and Physiological Measurement

Dielectric properties of body tissues

Ronald Pethig · 1 Nov 1987

A review is given of the dielectric properties of various mammalian tissues and biological fluids for the frequency range from 1 Hz to 10 GHz. The properties considered are the frequency variations of the relative permittivity and electrical conductivity. An attempt has been made to present data which can be considered to be the most…

The Sheffield data collection system

Brian Brown, Andrew Seagar · 1 Nov 1987

Because of the intrinsically low sensitivity of any surface potential measurement to resistivity changes within a volume conductor, any data collection system for impedance imaging must be sensitive to changes in the peripheral potential profile of the order of 0.1%. For example, whilst the resistivity changes associated with lung ventilation and the movement of blood…

Reference values for resting blood flow to organs of man

Larry R. Williams, R. W. Leggett · 1 Aug 1989

The lack of a reliable quantitative description of blood flow in man has hampered the development of accurate biokinetic models of essential elements, drugs, imaging agents, and carcinogens. In this paper we review and analyse data on blood flow and identify representative percentages of cardiac output and absolute blood flow rates to organs and tissues…

Applied potential tomography: possible clinical applications

Brian Brown, D C Barber, Andrew Seagar · 1 May 1985

Applied potential tomography (APT) or electrical impedance imaging has received considerable attention during the past few years and some in vivo images have been produced. This paper reviews the current situation in terms of what in vivo results have been and are likely to be obtained in the near future. Both static and dynamic imaging…

Non-invasive estimate of the mechanical properties of peripheral arteries from ultrasonic and photoplethysmographic measurements

Y. Tardy, J.‐J. Meister, Florent Perret et al. · 1 Feb 1991

The non-linear elastic response of arteries implies that their mechanical properties depend strongly on blood pressure. Thus, dynamic measurements of both the diameter and pressure curves over the whole cardiac cycle are necessary to characterise properly the elastic behaviour of an artery. We propose a novel method of estimating these mechanical properties based on the…

Clinical Physics and Physiological Measurement template — frequently asked questions

How do I write a paper in the Clinical Physics and Physiological Measurement format?
In DocuGuru you write your manuscript in a normal editor — no LaTeX setup required — and select the Clinical Physics and Physiological Measurement template. When you export, DocuGuru compiles the paper into the official IOP Publishing format and hands you a submission-ready PDF along with the editable LaTeX source.
What reference style does Clinical Physics and Physiological Measurement use?
Clinical Physics and Physiological Measurement uses Numbered (IOP) references, shown as numbered [1], [2] markers in the text. DocuGuru formats every in-text citation and the reference list in this exact style automatically. A reference appears like this: [1] Smith A, Jones B and Lee C 2023 A representative article title Clinical Physics and Physiological Measurement 12 45–58
Do I need to know LaTeX to submit to Clinical Physics and Physiological Measurement?
No. DocuGuru generates the iopjournal LaTeX class and compiles the PDF for you in the background, so you get a IOP Publishing-ready Clinical Physics and Physiological Measurement document without writing any LaTeX. If you do want it, the LaTeX source is included in the export.
Can I import an existing draft into the Clinical Physics and Physiological Measurement template?
Yes. Paste or upload your current manuscript — Word, LaTeX, Markdown, or plain text — and DocuGuru reflows it into the Clinical Physics and Physiological Measurement format with correct headings, figures, tables, and numbered citations.
Who publishes Clinical Physics and Physiological Measurement?
Clinical Physics and Physiological Measurement is a physics journal published by IOP Publishing. DocuGuru's Clinical Physics and Physiological Measurement template matches IOP Publishing's official submission format.
Can I export a submission-ready Clinical Physics and Physiological Measurement PDF?
Yes — DocuGuru produces a PDF built with the official Clinical Physics and Physiological Measurement template (the iopjournal class) that is ready to submit to IOP Publishing, together with the matching LaTeX source files.
How much does the Clinical Physics and Physiological Measurement template cost?
You can start writing in the Clinical Physics and Physiological Measurement template for free. Exporting the final submission-ready Clinical Physics and Physiological Measurement PDF and LaTeX source is part of DocuGuru's paid plans — see the app for current pricing.
Use the Clinical Physics and Physiological Measurement template