Write in a clean editor, then format for Journal of International Council on Electrical Engineering in one click — DocuGuru applies the official Taylor & Francis template with author–year references and exports a submission-ready PDF plus the editable LaTeX source. Free to start.
Journal of International Council on Electrical Engineering is a peer-reviewed journal published by Taylor & Francis, covering Microgrid Control and Optimization, Optimal Power Flow Distribution, Smart Grid Energy Management.
| Publisher | Taylor & Francis |
|---|---|
| Reference style | Author–year (Chicago, T&F) Author–year — (Smith, 2023) in the text Smith, Ada, Ben Jones, and Cara Lee. 2023. "A Representative Article Title." Journal of International Council on Electrical Engineering 12 (3): 45–58.
Formats any DOI in Journal of International Council on Electrical Engineering style. No sign-up. |
| Publishes research in | Microgrid Control and Optimization Optimal Power Flow Distribution Smart Grid Energy Management HVDC Systems and Fault Protection Smart Grid and Power Systems |
| ISSN | 2233-5951 |
| h-index | 18 |
| i10-index | 58 |
| Total citations | 2,068 |
| Article processing charge | $1,000 |
| Top institutions publishing here | Russian State Agrarian Correspondence University |
| Journal website | www.tandfonline.com |
| You get | A submission-ready PDF and the editable LaTeX source — ready to submit. |
Citations each year’s papers have accumulated so far — the most recent years are still building up.
The number of distributed energy components and devices continues to increase globally. As a result, distributed control schemes are desirable for managing and utilizing these devices, together with the large amount of data. In recent years, agent-based technology becomes a powerful tool for engineering applications. As a computational paradigm, multi-agent systems (MASs) provide a good…
AbstractWe are aiming at the development of epoxy composite materials with both high thermal conductivity and sufficient voltage endurance. A target is set as 10 W/m/K with 5 kV withstand voltage for power electronics applications. In order to achieve high thermal conductivity for polymers such as epoxy, it is a common method to fill inorganic…
This paper presents how to select tuning factor and quality factor in designing of a single-tuned passive harmonic filter. Tuning factor and quality factor must be considered before a decision of filter parameters(R, L and C). In literature, the study about these two factors has not been performed and only empirical values have been used…
Polypropylene (PP) film has been used in capacitors since 1970s. The high breakdown strength, low dielectric losses, and high availability make PP well suitable for use as capacitor dielectric. At the moment, the typical energy density achieved with PP film at room temperature is about 1.2 J/cm3. Recent research on PP films focus on improving…
Maximum Power Point Tracking (MPPPT) techniques are employed in PV systems to make full utilization of PV array output power which depends on solar irradiation and temperature. Recently, many MPPT algorithms and control schemes of PV system have been proposed, but different control methods and different PID controller parameters lead to different output efficiency and…
