Write in a clean editor, then format for International Journal of Reliability Quality and Safety Engineering in one click — DocuGuru applies the official World Scientific template with superscript references and exports a submission-ready PDF plus the editable LaTeX source. Free to start.
International Journal of Reliability Quality and Safety Engineering is a peer-reviewed journal published by World Scientific, covering Reliability and Maintenance Optimization, Software Reliability and Analysis Research, Statistical Distribution Estimation and Applications.
| Publisher | World Scientific |
|---|---|
| Reference style | Superscript numbered (World Scientific) Superscript — small raised numerals in the text 1. Smith, A., Jones, B. & Lee, C. A representative article title. International Journal of Reliability Quality and Safety Engineering 12, 45–58 (2023).
Formats any DOI in the closest standard style — International Journal of Reliability Quality and Safety Engineering has no published style definition, so this is an approximation. No sign-up. |
| Publishes research in | Reliability and Maintenance Optimization Software Reliability and Analysis Research Statistical Distribution Estimation and Applications Probabilistic and Robust Engineering Design Risk and Safety Analysis |
| ISSN | 0218-5393 |
| Citation impact (2-yr) | 1.49 |
| h-index | 38 |
| i10-index | 290 |
| Total citations | 9,761 |
| Top institutions publishing here | Tottori University |
| Journal website | www.worldscinet.com |
| You get | A submission-ready PDF and the editable LaTeX source — ready to submit. |
Citations each year’s papers have accumulated so far — the most recent years are still building up.
Most complex systems today contain software, and systems failures activated by software faults can provide lessons for software development practices and software quality assurance. This paper presents an analysis of software-related failures of medical devices that caused no death or injury but led to recalls by the manufacturers. The analysis categorizes the failures by their…
In this paper, software reliability models based on a nonhomogeneous Poisson process (NHPP) are summarized. A new model based on NHPP is presented. All models are applied to two widely used data sets. It can be shown that for the failure data used here, the new model fits and predicts much better than the existing…
This paper presents new sequential imperfect preventive maintenance (PM) models incorporating adjustment/improvement factors in hazard rate and effective age. The models are hybrid in the sense that they are combinations of the age reduction PM model and the hazard rate adjustment PM model. It is assumed that PM is imperfect: It not only reduces the…
Optimal solutions to the redundancy allocation problem are determined for systems designed with multiple k-out-of-n subsystems in series. The objective is to select the components and redundancy levels to maximize system reliability given system-level constraints. The individual subsystems may use either active or cold-standby redundancy, or they may require no redundancy. Previously, optimization methods for…
The Failure Mode and Effects Analysis (FMEA) documents single failures of a system, by identifying the failure modes, and the causes and effects of each potential failure mode on system service and defining appropriate detection procedures and corrective actions. When extended by Criticality Analysis procedure (CA) for failure modes classification, it is known as Failure…
