Write in a clean editor, then format for International Journal of Ceramic Engineering & Science in one click — DocuGuru applies the official Wiley template with author–year references and exports a submission-ready PDF plus the editable LaTeX source. Free to start.
International Journal of Ceramic Engineering & Science is a peer-reviewed journal published by Wiley, covering Advanced ceramic materials synthesis, Recycling and utilization of industrial and municipal waste in materials production, Concrete and Cement Materials Research.
| Publisher | Wiley |
|---|---|
| Reference style | Author–year (Chicago) Author–year — (Smith, 2023) in the text Smith, Ada, Ben Jones, and Cara Lee. 2023. "A Representative Article Title." International Journal of Ceramic Engineering & Science 12 (3): 45–58.
Formats any DOI in International Journal of Ceramic Engineering & Science style. No sign-up. |
| Publishes research in | Advanced ceramic materials synthesis Recycling and utilization of industrial and municipal waste in materials production Concrete and Cement Materials Research Advanced materials and composites Ferroelectric and Piezoelectric Materials |
| ISSN | 2578-3270 |
| Citation impact (2-yr) | 1.88 |
| h-index | 18 |
| i10-index | 53 |
| Total citations | 1,597 |
| Article processing charge | $2,640 |
| Open access | Yes |
| Top institutions publishing here | Pennsylvania State University |
| Journal website | ceramics.onlinelibrary.wiley.com |
| You get | A submission-ready PDF and the editable LaTeX source — ready to submit. |
Citations each year’s papers have accumulated so far — the most recent years are still building up.
Abstract Ultra‐high temperature ceramics (UHTCs) have emerged as promising materials for high‐temperature aerospace applications due to their high melting temperature and superior ablation performance. Even still, they have yet to reach their full potential due to the catastrophic brittle failure that typically accompanies the intrinsic low fracture toughness of ceramic materials. Therefore, the emerging field…
Abstract In the last 20 years, tape casting, a standard wet‐shaping process to produce thin ceramics, has been applied to manufacture polymer‐derived ceramics ( PDC s). Si‐based polymers, such as polysiloxanes and polysilazanes, also known as preceramic polymers ( PCP s), have been used as precursors/binders replacing conventional raw materials and additives for tape casting…
Abstract This article reviews promising studies on the design, manufacturing, microstructure, properties, and applications of glass‐ceramics containing ZrO 2 and relevant glass‐ceramic matrix composites. After the addition of ZrO 2 to a glass‐ceramic composition, it can persist in the residual glassy phase, facilitate nucleation, and/or precipitate as ZrO 2 or another zirconate crystalline phase. Also,…
Abstract The effect of polymer infiltration and pyrolysis (PIP) cycles with polycarbosiloxane on the microstructure, air leak rate, and properties of SiC composites manufactured by a combination of binder jet 3D printing and PIP is reported. The density, Young's modulus and flexural strength of disk‐shaped components increased with the number of PIP cycles. In the…
Abstract High‐tech ceramics are typically engineered by controlling point defects and interfaces while one‐dimensional dislocations have found much less attention so far. Nevertheless, their impact on almost any functional property and the sudden ease to fabricate them with novel synthesis methods, such as rapid densification, brings spotlight attention to dislocations as design dimension. Although the…
