Write in a clean editor, then format for International Journal of Microstructure and Materials Properties in one click — DocuGuru applies the official Inderscience template with author–year references and exports a submission-ready PDF plus the editable LaTeX source. Free to start.
International Journal of Microstructure and Materials Properties is a peer-reviewed journal published by Inderscience, covering Metallurgy and Material Forming, Microstructure and Mechanical Properties of Steels, Metal Alloys Wear and Properties.
| Publisher | Inderscience |
|---|---|
| Reference style | Author–year (Harvard/AGSM) Author–year — (Smith, 2023) in the text Smith, A., Jones, B. and Lee, C. (2023) 'A representative article title', International Journal of Microstructure and Materials Properties, 12(3), pp. 45–58.
Formats any DOI in International Journal of Microstructure and Materials Properties style. No sign-up. |
| Publishes research in | Metallurgy and Material Forming Microstructure and Mechanical Properties of Steels Metal Alloys Wear and Properties Aluminum Alloys Composites Properties Metal and Thin Film Mechanics |
| ISSN | 1741-8410 |
| Citation impact (2-yr) | 0.15 |
| h-index | 19 |
| i10-index | 66 |
| Total citations | 2,451 |
| Top institutions publishing here | University of Ljubljana |
| Journal website | www.inderscience.com |
| You get | A submission-ready PDF and the editable LaTeX source — ready to submit. |
Citations each year’s papers have accumulated so far — the most recent years are still building up.
This paper aims to highlight challenges of residual stress and part distortion in civil airframe manufacture as this is a recurring expensive problem as significant costs have been spent to correct part distortion at various stages of the manufacturing life cycle. It is our long term commitment and aspirations to understand and if possible, eliminate…
The results of the stress relieving and tempering processes are dependent on the temperature and time of the process, which may be correlated using a parameter such as Holloman's (Holloman-Jaffe) parameter or the Larsen-Miller parameter. These parameters are a measure of the thermal effect of the process on the metallurgical transformation of the steel during…
The paper describes regularities of a non-stationary nucleate boiling process during quenching of steels in a liquid media. A generalised correlation for the calculation of the nucleate boiling process duration is obtained. A definition of a self-regulated thermal process that takes place during quenching is introduced. During the self-regulated thermal process, the surface temperature of…
This paper describes the recent development of models in JMatPro for the calculation of phase transformations and material properties that are critical to the prediction of distortion during the heat treatment of steels. The success of these models is based on the accurate description of all the major phase transformations taking place, including the formation…
The influence of Deep Cryogenic Treatment (DCT) on the properties of AISI-M2 is evaluated. Hardness,(apparent) fracture toughness and wear resistance were measured after submitting this steel to conventional vacuum heat treatment, including quenching and triple tempering and three variants including DCT before and after tempering. In any case, only minor differences in hardness and a…
